Sligh Clock Grandfather
Some time or different you will have to transfer your lengthy case clock whether or not it’s in the technique of shifting home or simply time to wash behind the case and move it for decorating. Quite a lot of injury can be done by just picking the clock up and moving it in one piece with out taking plenty of precautions So whether or not you’re shifting your grandfather clock ten foot or ten mile Always
1. Wind up the clock so the weights are as near the seat board as you can get them, but keep in mind you want to have the ability to put the weights again onto the pulley hooks when reassembling, so leave yourself some room to carry the pulleys with one hand whereas holding the weight with the other. A very good guide line is to wind the pulleys as much as simply above the trunk door top.
2. Take of the hood to show the movement and dial and place masking tape or the like over the intestine line that’s across the strike and going barrels, this can stop the intestine line from springing out and getting tangled while you take off the weights and will maintain everything in place while you carry the motion and dial from the case.
3. Take off the weights and it’s a good idea to mark them by sticking a piece of masking tape on to each one and writing on them L (Left) and R (Right) or one, two and three within the case of a modern clock with a chiming movement that has three weights, this can ensure the weights go back in the fitting place, as you will see whenever you raise them there is a difference in weight.
4. Now take the pendulum off the motion, being very careful to not harm the skinny suspension spring (thin piece of spring metal) on the top of the pendulum which is threaded via the crutch behind the movement.
5. You can now lift the movement and dial from the case and away from the trunk cheeks by lifting the entire thing up with the seat board and inserting it in its packing case. It is best to pack the motion and dial stood upright within the field making sure the underside of the dial will not be crushing the gut lines. This can even maintain the entrance of the dial and clock hands safe, plus the added bonus of preserving the crutch at the back of the movement from possible harm or bending.
6. Your clock is now able to be moved safely to its new location. To reassemble just reverse the dismantling procedure put the clock into beat and you’re up and running.
7. If transporting the clock in your personal vehicle be certain the clock case is secure and will not slide, stopping any injury to the veneers or mouldings. We’ve got discovered it’s wise to protect the suspension spring on the end of the pendulum by taping it to a chunk of thick card to forestall it kind being damaged or bent, also ensure the weights are stowed very well as you do not need 12lb weights rolling around the boot or foot properly of your car.
If using knowledgeable moving firm it is all the time greatest to dismantle and pack your grandfather clock prepared for the removal men to transport. As most are very properly experienced in moving furniture only a few understand the workings of a clock and attempts to move longcase clocks with out utilizing these precautions will inevitably cause injury that is not detected till long after the move has been taken, and by that point they have lengthy gone typically leaving the owner with a very massive restore bill.
At Longcasegrandfatherclocks.org you’ll find products, information, and resources on grandfather clock movements, longcase grandfather clock, and sligh grandfather clock parts.